Jeep Cherokee Upper Control Arms

3 Items

  • Upper A-arms for 02'-07' lifted Jeep Liberty's
    PRE-ASSEMBLED KIT - FITS LIFT TYPE
    Spring Lift or Leveling Kit [1 to 3.5-inch lift]

    Spacer Lift, Leveling kit, and Spring lift kit

    These kits cause the upper arms to angle downward toward the ball joints. The Leveling kit or strut lift removes the factory rake angle by lifting the front level with the rear of the vehicle.

    Spring kits remove the factory rake angle and lift the rear of the vehicle about 1.5" - 2.5"

    $475.00
  • JBA Upper A-arms for 08'-12' lifted Jeep Liberty's
    PRE-ASSEMBLED KIT - FITS LIFT TYPE
    Spring Lift or Leveling Kit [1 to 3.5-inch lift]

    Spacer Lift, Leveling kit, and Spring lift kit

    These kits cause the upper arms to angle downward toward the ball joints. The Leveling kit or strut lift removes the factory rake angle by lifting the front level with the rear of the vehicle.

    Spring kits remove the factory rake angle and lift the rear of the vehicle about 1.5" - 2.5"

    $475.00
  • Replacement Ball joint, Sold individually, order two for a set.
    REPLACEMENT PART
    $67.00

Jeep Cherokee Lifts Require Upper Control Arm Upgrades

The third and fourth-generation Jeep Cherokee are known as the Jeep Cherokee KJ (2002-2007) and Jeep Cherokee KK (2008-2012), respectively, and were branded in the United States as Jeep Liberty. With the right modifications, both of these models are exceptionally capable off-road machines.

JBA Offroad manufacturers upper control arms (also known as UCAs or upper a-arms) for both the KJ Jeep Cherokee and KK Jeep Cherokee.

These Jeep Cherokee models have independent front suspension and require replacement of factory upper control arms when lifted. If factory UCAs are not replaced, your Jeep Cherokee alignment and clearances will be both incorrect and unsafe.

When Jeep Cherokees are lifted, caster is lost from the front-end alignment. Caster is critical for stability over 45 miles per hour and returns the steering wheel to center after going around a corner. Additionally, factory upper control arms often rub on the front springs at certain articulations. If factory a-arms are not replaced when lifting a Jeep Liberty, expensive and dangerous damage is likely.

JBA led the industry back in 2004 with the development of the first aftermarket upper control arms, which enabled the vehicles with independent front suspension to be safely lifted. Today, JBA upper control arms are installed on thousands of vehicles, including lifted Jeep Cherokees, and driven all over the world. JBA UCAs work with Jeep Cherokee lift kits up to 4 inches above factory ride height.

All JBA manufactured parts come with JBA 12-month 100% satisfaction guarantee. If for any reason you are not 100% satisfied with purchase, you can return it to us for a refund of your purchased price within the first 12 months.