Jeep Commander Upper Control Arms

PRE-ASSEMBLED KIT - FITS LIFT TYPE

Spring Lift or Leveling Kit [1 to 3.5-inch lift]
Spacer Lift, Leveling kit, and Spring lift kit

These kits cause the upper arms to angle downward toward the ball joints. The Leveling kit or strut lift removes the factory rake angle by lifting the front level with the rear of the vehicle.

Spring kits remove the factory rake angle and lift the rear of the vehicle about 1.5" - 2.5"

Spring Lift with Cradle Drop Kit
Spring lift kit with Cradle Drop Kit

These kits cause the upper arms to angle downward toward the ball joints. The cradle drop lift, cross-member drop, or drop bracket lift kit with spring kits.

Example: 4" cradle drop lift with a 2" spring/coil over lift = 6" lift kit. 6" cradle drop lift with a 2" spring/coil over lift = 8" lift kit. When the mounting holes are offset by 4" and the kit is a 6" kit, the other 2 inches are made up from the strut lift or spring lift.

JBA Upper Control Arms for lifted Grand Cherokee & Commander 2005-2010

$540.00
REPLACEMENT PART

JBA Max 90 Upper Ball Joint

$67.00

Jeep Commander Lifts Require Upper Control Arm Upgrades

The Jeep Commander is also known as the Jeep Commander XK (2005-2010). There was also an diesel version of the Commander available outside of the United States which was known as the Jeep Commander XH.

JBA Offroad manufacturers upper control arms (also known as UCAs or upper a-arms) for the Jeep Commander . With the right modifications, Jeep Commander models are wonderfully capable off-road vehicles.

All Jeep Commander models have independent front suspension and require replacement of factory upper control arms when lifted. If factory UCAs are not replaced, your Jeep Commander alignment and clearances will be both incorrect and unsafe.

When Jeep Commanders are lifted, caster is lost from the front-end alignment. Caster is critical for stability over 45 miles per hour and returns the steering wheel to center after going around a corner. Additionally, factory upper control arms often rub on the front springs at certain articulations. If factory a-arms are not replaced when lifting a Jeep Commander, expensive and dangerous damage is likely.

JBA led the industry back in 2004 with the development of the first aftermarket upper control arms, which enabled the vehicles with independent front suspension to be safely lifted. Today, JBA upper control arms are installed on thousands of vehicles, including lifted Jeep Commanders, and driven all over the world. JBA UCAs work with Jeep Commander lift kits up to 4 inches above factory ride height.

All JBA manufactured parts come with JBA 12-month 100% satisfaction guarantee. If for any reason you are not 100% satisfied with purchase, you can return it to us for a refund of your purchased price within the first 12 months.